Rockwall Air Conditioning 214-261-5608

Rockwall Air Conditioning

What should Rockwall residential and commercial air conditioning units cost?

There are essentially two costs when purchasing and installing a new central air conditioning: equipment costs and labor costs. Depending on your situation, you may be able to reduce your costs in one or both of these areas.

Probably the single-greatest cost-saving solution is to take your time replacing a worn out or broken down air conditioning equipment. That’s hard to do when your unit is fried and its 100 degrees plus for the next week. Always hire a licensed Rockwall HVAC contractor to install it. Get bids from at least three different companies. Dallas Texas Air Conditioning hopes we are one of them. Make sure you are specifying the exact same equipment in each of the proposals. You are not comparing apples to apples when you compare the cost of a SEER 13 to a SEER 21 a/c unit.

Rockwall Air Filters and Filtration Systems

Stop reading this and change your filters now. Come back when you finish.

Now, keeping the filters fresh, changing them once a month, will keep your duct work clean. It will also cut down on your need to clean you coils in the plenum. Clean coils will make your system run more efficiently and save you money on utility bills and furure repair costs, so this is important.

Filtration systems are a different thing. These super scrub the air so your family has cleaner air to breath. This is improtant if allergies are an issue in your Rockwall, TX home.

Rockwall Air Conditioning

Buying a Central Air Conditioning in Rockwall TX

Factors to consider before signing that proposal:

• Are you paying a reasonable price for your air conditioning equipment?
• What capacity of air conditioning should residents of Rockwall buy?
• Should you buy a high, middle, or low-efficiency air conditioning equipment?

Air Conditioning Dallas can help you answer each of these questions.

Rockwall Furnace and Heat Pumps

Study the information about the furnace, too. Your choices between the different levels of efficiency available in furnaces can have an impact on the total price. In fact, don’t hesitate to ask for a “good”, :better”, “best” solution with pricing on different combinations of furnaces and air conditioning, heat pumps or dual fuel heating and cooling units.

Rockwall Furnace

As with installing a furnace or heat pump, you will need to work with a good Dallas HVAC contractor when you install a new central air conditioning system. Make sure that you get quotes from at least three Rockwall contractors. This will ensure you a low, medium and high bid, and give you a good sense of what it is reasonable to pay. Also, make sure to screen your potential contractors to ensure that they have happy customers and few if no complaints.

You can use Dallas Air Conditioning for an HVAC contractor. All of our technicians have been pre-screened for drugs and background.

Rockwall Air conditioning: Choosing the Right Size

It is important to have an Rockwall HVAC Contractor perform a load calculation before you decide which size air conditioning system to buy. If you install an air conditioning which is too large, it will cycle on and off too often, substantially reducing the efficiency of the system. If the heating and air unit is too small, and your air conditioning may not be able to meet the demands of a hot, humid day.

The industry standard load calculation is called the Manual J calculation. It takes into account the size of your house, the amount of insulation installed, the square footage, and a host of other factors.

Rockwall Central Air conditioning Efficiency

The most common measure of the efficiency of a consumer central air conditioning system is the SEER (Seasonal Energy Efficiency Ratio). Beginning in 2006, an air conditioning installed in Rockwall must have a SEER of at least 13 to be sold in the United States. Higher efficiency models have a SEER between 14 and 22.